The advent of manifold mounted, plug-in pneumatic valves has been a boon for machine builders. It allows them to mount complete valve packages in a safe and secure location on a machine. Using a D-sub connector, serial interface module, or similar single-point wiring system, all of the electrical control outputs can feed into one location on the manifold, greatly simplifying the wiring. Plumbing issues are reduced, since a single air pressure line can be used to feed a common pressure gallery. The same advantage applies to the common exhaust gallery. No longer would both a plumber and an electrician be required to replace a valve, since any valve can be replaced without disturbing electrical connections or plumbing lines.
Why So Many Air Leaks - Even Today?!
Energy conservation has been much talked about lately, in the media, the government, and at the water cooler. Lean manufacturing is also a popular topic these days, as are any ways to increase productivity, reduce costs, and increase profitability.
When it comes to conserving energy in compressed air nothing is sexier than a big, old, oil-free 300 horsepower variable speed drive air compressor coupled with a heat of compression dryer tied to an energy management system with all the trimmings. If you’re like me, it’s hard not to let out a manly grunt after reading that sentence.
